Tuff Country 14059 - GM 2014 Silverado 1500 4wd 4 lift kit - Manual (Page 3)

Hardware bag 14059NB includes:
Description Quantity
7165B (7/16” x 5” bolt) 4
38WA (3/8” USS flat washer) 8
716UN (7/16” unitorque nut) 4
9163B (9/16” x 3” bolt) 2
916UN (9/16” unitorque nut) 2
12WA (1/2” USS flat washer) 4
M1055B (10 mm x 55 mm bolt) 4
M10WA (10 mm flat washer) 8
M10UN (10 mm unitorque nut) 4
SERT04 (grease sert) 4
38NLN (3/8” nylock nut) 6
516WA (5/16” USS flat washer) 6
M6UN (6 mm unitorque nut) 2
M6WA (6 mm flat washer) 2
Hardware bag 14059PL includes:
Description Quantity
S10051 (1.750” x .510” x .950” sleeve) 4
PB69137 (poly bushing) 8
S10231 (.750” x .563” x 2.170” sleeve) 4
SHOCKTIE (zip tie) 4
Hardware bag 916NW includes:
Description Quantity
SUW-916 (9/16” u-bolt washer) 8
916HN (9/16” u-bolt high nut) 8
Please follow instructions carefully:
Before installation begins, measure from the center of
the hub, to the bottom of the fender well, and record
measurements below.
Pre-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:__________________________________
Passenger side rear:______________________________
At the end of the installation take the same
measurements and compare to the pre-installation
measurements.
Post-installation measurements:
Driver side front:_________________________________
Passenger side front:_____________________________
Driver side rear:_________________________________
Passenger side rear:______________________________
Front end installation:
1. To begin installation, block the rear tires of the vehicle so
that the vehicle is stable and can’t roll backwards. Safely lift
the front of the vehicle and support the vehicle with a pair of
jack stands. Place a jack stand on both the driver and the
passenger side. Next, remove the front wheels and tires
from both sides.
2. Remove the OE skid plate, set aside and save the OE
hardware.
3. Carefully disconnect all (3) electric wiring harnesses from
the rack and pinion.
4. Working on the driver side, remove the rear cross mem-
ber from the OE location. Save the cross member and hard-
ware.