Tuff Country 56901 - Toyota Tacoma 05-14 performance 6 lift kit - Manual (Page 14)

51. Working on the driver side, install the new bump stop
spacer and bump stop in the stock location. Make sure to
use thread locker or loctite. Repeat on passenger side.
52. Working on the driver side, remove the sway bar end link
from the sway bar. Save the stock sway bar end link and the
stock hardware. Repeat on passenger side.
53. Working on the driver side, install the driver side end link
on the passenger side of the stock sway bar. Then install the
passenger side end link onto the driver side. Make sure to
use thread locker or loctite and torque to 32 ft lbs.
54. Working on the driver side, thread the lower stud of the
sway bar end link into the neck of the new steering knuckle,
you will need to use an allen wrench and turn it counter-
clockwise to install it. Special note: Tuff Country recom-
mends coating the threads of the sway bar end link with
Anti-seize in case it ever needs to be removed again.
Also, it is sometimes necessary to disconnect the top of
the sway bar end link from the sway bar to be able to
thread into the steering knuckle.
55. Locate the new upper driver side differential breather
hose bracket from hardare bag 56900NB1. Also, locate (1)
5/16” x 3/4” bolt (3) 1/4” USS flat washers and (1) 5/16” uni-
torque nut from hardware bag 56900NB bag # 2. This brack-
et is used to space the stock steel breather hose bracket
upwards. Install the new bracket so that you use the stock
bolt with a new 1/4” USS flat washer spacing it from the dif-
ferential, then use the new 5/16” bolt and hardware to con-
nect the new bracket to the stock one.