Tuff Country 56901 - Toyota Tacoma 05-14 performance 6 lift kit - Manual (Page 17)

65. Locate the stock hardware that connected the stock
caliper to the stock knuckle. Working on the driver side,
install the brake caliper onto the new steering knuckle. Make
sure to use thread locker or loctite and torque to 86 ft lbs.
Repeat on passenger side.
66. Working on the driver side, install the ABS brake sensor
wire to the upper control arm using the stock bolt and brack-
et. Make sure to use thread locker or loctite. Repeat on
passenger side.
67. Working on the driver side, install the stock brakeline
bracket to the neck of the new steering knuckle using the
stock bolt. Make sure to use thread locker or loctite. Repeat
on passenger side.
68. Locate the (2) new front brakeline relocation bracket
from hardware bag 56900NB1. Locate (2) 5/16 x 3/4” bolt,
(4) 1/4” USS flat washers and (2) 5/16” unitorque nut from
hardware bag 56900NB bag # 2. Working on the driver side,
install the new brakeline bracket using the stock bolt to
secure it to the frame and the new 5/16” bolt to connect the
stock brakeline bracket to the new one. Repeat on passen-
ger side. Special note: Be extra carefully to not kink the
steel brakeline when performing this step.
69. Working on the driver side, using the stock bolt, install
the stock ABS wire bracket to the lower mounting position on
the new steering knuckle. Repeat on passenger side.
70. Working on the driver side, using the stock bolt, install
the ABS sensor into the new steering knuckle. Repeat on
passenger side.
71. Working on the driver side, install the tie rod end into the
new steering knuckle and secure using the stock nut and
cotter pin. Torque to 48 ft lbs. Special note: If you are not
able to install the stock cotter pin because the hole in
the tie rod does not line up with the castle nut, DO NOT
loosen, tighten the castle nut until the stock cotter pin
can be installed. Repeat on passenger side.