Tuff Country 56901 - Toyota Tacoma 05-14 performance 6 lift kit - Manual (Page 15)

56. Move to the lower control arm adjustable cam bolts and
tighten all 4 of them. Special note: The cam bolts will be
adjusted during the alignment process, so it is not criti-
cal where they are set until then. Make sure to tighten
both the driver and passenger side.
57. Working on the new front cross member hardware, add
some thread locker or loctite to the new 3/4” hardware and
torque to 145 ft lbs. Make sure to tighten both the driver
and passenger side.
58. Working on the new rear cross member hardware, add
some thread locker or loctite to the new 1/2” hardware and
torque to 85 ft lbs. Make sure to tighten both the driver
and the passenger side.
59. Move back to the (6) new bolts holding the new skid plate
to the new front and rear cross member and add some
thread locker or loctite and torque all (6) bolts to 48 ft lbs.
60. Working on the driver side differential bracket, add some
thread locker or loctite and torque the (3) stock bolts that
connect the bracket to the differential to 75 ft lbs. Add some
thread locker or loctite and torque the new 1/2” bolt and
hardware that
connects the
bracket to the new
front cross mem-
ber to 68 ft lbs.