Aiwa XR-DV3M - Manual (Page 15)

ENGLISH
13
En
AUDIO CD
OPERA
TIONS
SELECTING A TRACK
r , t
r , t
c
c / d
0-9,+10
SELECTING A TRACK WITH THE REMOTE
CONTROL
A track can be selected directly by entering the track number on
the remote control, either during play or in stop mode.
Press the numbered buttons for the desired track.
Example:
To play track 12, press +10, 2.
To play track 20, press +10, +10, 0.
Play begins at the beginning of the selected track and continues
to the end of the disc.
FAST FORWARD/REVERSE PLAY
Hold down r or t during play or in pause mode
until the guide display such as " g x 5" appears.
The disc is played 5 times faster than the normal speed.
To return to normal play, press
c .
To change the playing speed
During fast forward/reverse play, hold down r or t until the
guide display appears.
This operation switches the playing speed between 5 times and
16 times.
SKIPPING
Press r or t .
With each press of t , the disc position skips to the succeeding
track.
When r is pressed once, the disc position skips back to the
beginning of the current track.
When
r is pressed twice or more, the disc position skips back
to the previous track(s).
STOPPING AND PAUSING
To stop play
Press s .
Play stops. The unit remembers the point at which play stopped.
("RESUME" appears on the display.)
To resume play from the point where it stopped
Press c .
To clear the point to be resumed
Press s again in stop mode.
"RESUME" disappears on the display. The resume memory is
cleared, and play starts with the first track when
c is pressed the
next time.
NOTE
• Under the default setting, the point to be resumed is also cleared
when the disc door is opened, the power is turned off, or the
function is switched.
• Set up can be changed so that the resume memory is retained
even after the conditions described above. (See "DISC
RESUME", page 47).
To pause play
Press a .
To resume play, press c .
MARKING AND SEARCHING
Marking
You can mark any point in a CD and start play from there.
For details, see "MARKING", page 28.
Searching
You can locate a desired point on the CD by using the time search
function, i.e., by specifying the time from the beginning of the CD.
For details, see "TIME SEARCH", page 29.
REMOVING THE DISC
Stop play, and press z OPEN/CLOSE.
The disc door opens so that the loaded disc can be removed.
After removing the disc, press
z OPEN/CLOSE again to close
the disc door.