Atek electronic Stagehand RM200 - Manual (Page 15)

Stagehand User’s Manual, page 14
How to reprogram the receiver
Add ID code and channel:
(If you are reprogramming for the purpose of avoiding conflicts, skip to the next section
since you will first want to erase all ID codes and channels)
With the USB receiver plugged into the powered on computer, take a narrow
instrument, such as the uncurled end of a paperclip, and push and hold the reprogram
button on the USB receiver until the LED indicator on the receiver (not the LED
illumination light on the remote control) flashes two times.
Then quickly release the button within 1.5 seconds.
Next, push the up button or down button on the remote control several times so that
the USB receiver can receive signals from the remote control.
If the LED on the receiver flashes when you send signals, this indicates that the
receiver has learned the new ID code and channel. It will still respond to its original
and any previously added ID codes and channels as well (as long as you have not
erased them per the procedure described further below).
Note: the receiver will abandon the process of adding a new ID code and channel if you
wait more than 15 seconds to send a signal from the remote control or if you unplug
the receiver. Also, since the receiver will not add the ID code and channel of a remote
control it already is actively programmed to recognize, if you send a signal from your
currently recognized remote control(s), the LED on the receiver will not accept it and
will not flash during this 15 second reprogramming period.
You can repeat this procedure up to seven times for a total of eight learned ID codes
and channels that will operate simultaneously. If you try to add more than seven
additional ID codes and channels, the LED will flash but no ID code and channel will
be added.
Operation