Actron KAL9640B - Manual (Page 28)

Using The Scan Tool
3 – 4 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
3
Scan Tool Setup
Tool Setup allows you to change the
measurement units and LCD contrast,
turn beeper On/Off and display tool
information. The settings remain until
the internal batteries become
discharged.
Measurement Units
To change the measurement units, use
the UP/DOWN arrow keys to select
English/Metric and press ENTER.
In the Measurement Units menu,
select English or Metric and then press
ENTER. English is the default.
Press
ENTER again to return to the Setup Tool menu.
Changing Display Contrast
The display contrast can be adjusted
from the Tool Setup menu. Select
Display Contrast and press ENTER.
Use the UP/DOWN arrow keys to
increase and decrease the contrast.
Press ENTER to save the setting and to
return to the Setup Tool menu.
Beeper
Beeper selection allows the user to turn Off the tool’s beeper. The bell symbol
~ will not appear in the lower right hand corner of the display when the beeper
is off.
Tool Information
This function allows you to view specific
tool information that may be needed when
contacting customer service.
Select Tool Information with the
UP/DOWN arrow keys and press ENTER.
The information shown to the right displays
on the screen. Use the UP/DOWN arrow
keys to view all the lines.
Press the
BACK or ENTER key to return to
the Setup Tool menu.
✓
Write this information in the space provided on the inside of the front cover.
Main Menu ?
` Vehicle Diagnosis
Tool Setup [
Tool Self-Tests ~
Setup Tool
` 1)English/Metric
2)Display Contrast [
3)Beeper ~
] Increase Contrast
[ Decrease Contrast
Press ENTER To Save ~
Tool Information:
` Serial No:10000085
SW ID: 945BH
HW Ver: 0
Boot Ver: 0
Prod ID:3
Board ID: 10
Burn Date:03/07/02