Axis Communications 660 - Manual (Page 11)

Setup for NetWare AXIS 560/660 User’s Guide 10
Ne
tW
ar
e
Setup for NetWare
NetWare Using NDPS over IP
Important:
Note:
Having assigned an IP address to the AXIS 560/660 as described in, Assigning an IP
Address, on page 8, you are now ready to install the AXIS 560/660 for NDPS printing
over IP. Follow the instructions below:
1. Connect the AXIS 560/660 to the NetWare network, if it is not already
connected. Refer to Connecting the printer to the Network, on page 7 for more
information.
2. Start the NetWare Administrator. Create an NDPS Manager object, if you do not
have one available.
3. Proceed to create the printer objects as Public or Controlled Access printers.
Please refer to the appropriate Novell documentation for instructions on creating
NDPS Manager objects and the printer objects.
Notes:
If you want to print in NDPS, make sure that you have NDPS software istalled on your NetWare
file server.
You can select to install the connected printers as Public or Controlled Access printers.
The HP_JETADMIN parameter of the AXIS 560/660 must be set to YES in order for the
comunication between the AXIS 560/660 and th NDPS gateway to be enabled.
NDPS requires that you run NetWare 4.11 or higher.
During the creation of the printer object, you must choose the IP address of the AXIS 560/660.
Depending on which port you have connected printer, you should enter LPT1, LPT2 or COM1 as
your printer port when prompted during the creation of the printer object.
To print using TCP/IP, Axis print server firmware 6.1 or later is required. In order to print using
IPX/SPX, Axis print server firmware 5.51 or later is needed.