Pure DRX-601 series tuners - Manual (Page 7)

5
Switching on for the first time
Before switching on for the first time, check all connections and ensure that the volume on your amplifier is low.
1. Push and release the Power button to switch the unit on. The blue power LED will light up.
2. Press the Autotune button to enter first time setup mode.
3. Rotate the tuning button to select your tuning zone; UK, Canada or Rest of World and press the Autotune button
again to confirm your selection.
4. Rotate the tuning button to select the language your DRX-602ES will use for display text. Press the Autotune
button to confirm your selection and start the autotune process.
When autotune is complete you will hear the first service found and its name will be shown on the display. All the
services found are now stored in the unit and setup is complete.
If you want to change any of these settings, follow the instructions given in the sections below.
Using your DRX-602ES
This section provides information on using your DRX-602ES including tuning, selecting a service and altering the displayed information.
Selecting a service
Once you have tuned your DRX-602ES you can use the turn-and-push tuning button to select digital radio services.
1. Rotate the tuning button to see the names of the stored services on the bottom line of the display. Stop when you
find the service to which you want to listen.
2. Push and release the tuning button to confirm your selection. The service name will be displayed on the top line of
the display
If the service you select is in stereo, the Stereo LED will light up. If the service you select has one or more secondary
services available, the Secondary LED will light up. For information on primary and secondary services, see Guide to
Digital Radio. For details on selecting primary or secondary services, see Using the remote control.
If reception is poor, check the signal strength and try repositioning your aerial using the signal strength indicator, see
Using your DRX-602ES: Viewing extra information.
Changing the display mode
The DRX-602ES has four display modes which enable you to view different elements of the broadcast data on the
bottom line of the display. Press the Display button and repeat or hold to cycle through the four different display modes.
Dynamic Label Segment Scrolling text accompanying the audio, where available.
Program Type A description of the type of content being broadcast by the service.
Multiplex name The name of the multiplex in which the current service is found.
Technical Information The channel label and centre frequency for the current multiplex.
Changing the display brightness
The DRX-602ES has four levels of brightness which you can alter to suit the light level in your room.
Press the Brightness button and repeat or hold to cycle through the four brightness levels.