Pure DRX-601 series tuners - Manual (Page 8)

6
Viewing extra information
The DRX-602ES has two information modes. Press the Info button and repeat or hold to view the information modes.
Signal strength Displays the strength of the signal for the current multiplex. Maximum strength is shown by 16 bars.
If sound quality is poor you may be able to increase signal strength by repositioning your aerial.
Mode Displays the mode of the current service, Stereo (ST) or Mono (MN) and the data rate at which the
audio signal is being transmitted. The data rate is set by the broadcaster to suit the type and
quality of material being transmitted.
Changing your tuning zone
Your DRX-602ES can receive both Band III and L-band DAB transmissions. To speed up the autotune process you can
restrict the frequencies scanned by selecting one of three tuning zones: UK (Part of Band III), Canada (Band III +
Canada L-band) or Rest of World (Band III+Europe L-band). The tuning zone is selected when you first set up the unit.
To change your tuning zone:
1. Press and release the Autotune button three times.
2. Rotate the large tuning button to select the required zone and press the Autotune button again to confirm your
selection. You can now select the display language as described below.
Changing your display language
You can set the display to one of 11 languages. If you are setting your display language directly after setting your tuning
zone go straight to step 2 below.
1. Press and release the Autotune button four times.
2. Rotate the large tuning button to select the required language and press the Autotune button again to confirm
your selection. You can now tune your DRX-602ES as described below.
Switching on and off
We recommend that you switch off your DRX-602ES when not in use to prevent energy wastage. If you leave the unit
switched off for an extended period (around a month or longer) you may need to re-tune the unit to refresh the
available services.
Push and release the Power button to switch the unit on or off.
Tuning
Tuning the DRX-602ES is very simple. In most cases you only need to perform this operation once, when you first set up
the unit. If you are tuning directly after setting your display language go straight to step 2 below.
1. Push and release the Autotune button. The display will indicate tuning is underway.
2. If you want to cancel the autotune procedure, push and release the Autotune button a second time during tuning.
When finished, you will; hear the first service found and its name will be shown on the display. All the services
found are now stored in the unit.
If no services are found the display will show NO ENSEMBLES. Check your aerial connection and positioning and try the
tuning process again.
You may want to repeat this process in the future if you change your aerial position or if you want to receive a newly
introduced service.