Pure Avalon 300R Connect - Manual (Page 53)

49
Press the red (Apply) button.
Avalon will attempt to connect to the network and if successful will change the status to
‘Connected’.
Note: If you do not wish to connect to a network, you can select ‘No network’ in the
Configuration field.
Connecting to a wireless network
To connect to a wireless network using Wi-Fi, first ensure that Avalon is located within range of
your wireless access point.
Note: If you have a cabled network connection, Avalon will disable the wireless connection.
In the Network screen, select Wireless setup.
You can either scan for a wireless network that is in range or you can manually enter the details.
To scan for a network, select
Scan. The screen will display the ‘Scanning for access points’
message and will then display a list of networks that are in range.
Each network is listed with the network name (the SSID) and the following symbols:
poor signal strength
low signal strength
medium signal strength
full signal strength (preferred for On Demand use)
locked Wi-Fi
Select the network you wish to connect to and press the OK button.
If the network is locked, the Security Settings box will display. Select the type of security that is
in use and then enter the appropriate Key using the alphanumeric keys.
Note: Wi-Fi keys are case sensitive. Use the shift button to access capital letters on the
remote control alphanumeric keys. If you need to delete a letter, press the button.
Select Connect to connect to the wireless network.
Avalon will attempt to connect to the network and, if successful, the status will change to
‘Connected’.