Racing Electronics SC180 - Manual (Page 14)

Installing the Belt Clip
1. Place the Belt Clip on
the mounting area on
the back of the
scanner, making sure
the holes in the clip line
up with the threads in
the back of the
scanner.
2. Insert the 2 screws into the corresponding holes and
tighten.
CAUTION: Do not tighten the screws too tight. You could
damage the case or clip.
Using the Earphone
The PHONE jack at the top of the SportCat is a standard
3.5mm stereo phone jack. You can use either the supplied
earphone, or a stereo headset of the proper impedance
(32
W
). The output of this jack is monaural audio, but you
will hear it in both headphones of a stereo headset.
IMPORTANT!
Be sure to use only the supplied earphone, or stereo
headset of the proper impedance (32
W
). Use of an
incorrect earphone or stereo headset may be potentially
hazardous to your hearing.
WARNING: To avoid discomfort or possible
hearing damage, be sure to set the Volume
Control before plugging in the earphone or
proper headphones. A sudden opening of
the Squelch may cause unexpected loud
audio.
11