Racing Electronics SC180 - Manual (Page 22)

To access a specific channel:
1. Press .
2. Enter the channel number using the numeric keys.
3. Press again.
Priority Scan
The SportCat has 10 Priority Channels, 1 per Bank.
Initially these are the first channel in each Bank. (e.g.
Channel 1, Channel 11, Channel 21, and so on.) In priority
scan mode, the scanner checks the Priority Channel(s)
every 2 seconds during the Scan cycle. If a transmission is
received, the scanner will stop at that channel. If the
Priority Channel in any Bank is “Locked Out”, it will be
skipped during scanning.
You can move the Priority to any other channel in a Bank
as follows:
1. Go directly to that channel using any of the methods
described above.
2. Press and hold for at least 2 seconds. You will hear
“two beeps,” and P will appear on the display to the left
of the new channel number. That channel will now be
the Priority Channel for that Bank. (The P will no longer
appear for the previous Priority Channel.)
To activate Priority Scan, press . The PRIORITY
indicator will appear at the bottom of the display. To
deactivate Priority Scan, press
again. The PRIORITY
indicator will disappear from the bottom of the display.
Delay
Normally the scanner will resume scanning when a
transmission stops. If you want to remain on a channel
until a responding transmission is received, activate the
DELAY feature. This feature can be active in SCAN,
MANUAL, SEARCH, and WEATHER Modes.
1. Press . The DELAY indicator appears on the display.
The scanner will now pause 2 seconds after
transmission stops before resuming scanning.
2. Press again to deactivate Delay. The DELAY
indicator disappears from the display.
19