Racing Electronics SC180 - Manual (Page 18)

7. If that frequency is already stored in another channel,
you will hear a “beep”, and the other channel number will
appear on the display. If you want to store the frequency
in the selected channel (18) as well, press
again.
The frequency will blink twice to confirm the
programming. Or, you can press
and enter another
frequency for the currently selected channel.
Note: Any frequency already stored in any channel will
automatically be replaced by the new one.
8. If you try to enter a frequency that is outside one of the
12 Bands, you will hear a “beep”, and the word “Error
”
appears on the display.
Press and re-enter the correct frequency.
9. To program another channel, repeat the above
procedures.
Deleting a Stored Frequency
To delete a frequency from a channel:
1. Display the channel and frequency that is to be deleted.
2. Press on the numeric keypad.
3. Press . The current channel is erased, and the
display shows 000.0000.
Note: That channel will be skipped during scanning.
B. Programming SEARCH
The Search feature enables you to rapidly search for active
frequencies within the specified band limits. When an
interesting frequency is found, you can store it into a
channel using the procedure below. For more information
about SEARCH Mode, see the section titled “Searching”.
1. Press and hold / BAND to enter the BAND
SEARCH Mode.
15