Sandvik Coromant Threading - Manual (Page 60)

60
3. Products - thread turning
CoroCut® MB – internal threading
CoroCut MB has front-mounted exchangeable inserts for internal
machining in hole diameters from 10 – 25 mm (.394 – .984 inch).
Its sharp cutting edges give good results at low feeds.
Boring bars are available in steel and carbide, with through coolant.
The bars are to be used together with EasyFix clamping in up to 6
x bar diameter overhang.
• Sharp cutting edges
• Accurate clamping for correct orientation
• Round mounted exchangeable insert
• EasyFix for fewer vibrations and fast set-up
Assortment
Steel bars - for up to 3 x bar diameter overhang
Carbide bars - for up to 6 x bar diameter overhang
For cutting data information, refer to chapter 5, Technical reference (page 86) and for
infeed recommendations see chapter 5, Technical reference (page 111).