Abbingdon Music Research Compact Disk Processor CD-77 User Manual
Page 14
14
i.
Unpack the CD-77 and remove the protective foam insert inside the CD well.
ii.
Remove the protective sheet from the acrylic front panel.
iii.
Ensure the CD-77 is located on a level and solid surface capable of supporting at least 50 kgs.
iv.
Using the spirit level located inside the CD well, check the CD-77 is on a level platform
v.
Connect the IC-77 RCA-type interconnect via the left (blue/white) and right (red) leads to the
respective channels at the rear of the CD-77.
vi.
Connect the other end of the IC-77’s left and right channels to the respective inputs of the ampli-
fier. Ensure that the correct colour-coding is adhered.
vii.
Connect the IEC end of the PC-77 mains power cable to the mains receptacle of the CD-77 and
connect the mains plug into a mains socket power source.
Transporting/Moving the CD-77
Prior to any transportation/movement, ALWAYS replace the protective foam insert inside the CD well. Without
this, the CD door sensor may be knocked out of position due to the heft of the CD door moving in transit.
IF the protective foam insert has been misplaced, use sellotape to rigidly hold the CD door open prior to transpor-
tation.
Optional IC-77
(XLR-type)
interconnect can
be purchased
separately