Abbingdon Music Research Compact Disk Processor CD-77 - Manual (Page 20)

20
2. Standby
After start-up, pressing the STANDBY button (F1) on either the front fascia or the RC-77 (RC5), the CD-77
will switch to STANDBY mode.
Standby
By pressing this button again, the CD-77 will commence warm-up to prepare for operation.
Under STANDBY mode, power to CD-77’s digital circuit is kept active in order to provide the optimum per-
formance for the next listening session. However, power to the valves will be switched off to preserve valve life.
3. Loading (Autoplay)
To play a compact disc, slide back the top-loading CD door. Remove the CD puck and place the compact disc
in the large circular recess in the well, with its transparent playing surface facing down. The label side of the
compact disc MUST face UP.
Replace the CD puck in the center and close the lid. Make sure the CD puck is correctly centered and positively
engaged.
Close the CD door so that the CD-77 is able to scan the compact disc’s TOC (Table of Contents) and display the
total number of tracks and playing time.
Standby will
maintain power
to the non-valve
circuitry