Connecting to tactile transducers, Connecting to outdoor speakers, Wiring with aws all weather speakers – EarthQuake XJ-300FR User Manual
Page 14
Advertising
14 XJ-300FR Manual
Earthquake Sound Corp. | www.earthquakesound.eu
Connecting to Tactile Transducers
Make sure the front toggle switch is set to “Low Pass” if
connecting to a subwoofer or tactile transducer.
Note:
Wiring with 2 MQB-1 Tactile Transducers
Receiver/Processor
+
_
+
_
Do not wire 1 MQB-1
with the mono bridge
setting. Use either the
left or right speaker
output.
Connecting to Outdoor Speakers
Make sure the front toggle switch is set to “Bypass” if
connecting to speakers or a 2.1 channel system.
Note:
Receiver/Processor
Wiring with AWS All Weather Speakers
+
_
+
_
AWS 602 or AWS 802
This may overload the
speakers. Be sure to
not set the volume too
high.
Advertising