EarthQuake XJ-300FR - Manual (Page 6)

6 XJ-300FR Manual Earthquake Sound Corp. | www.earthquakesound.eu
Front Features
3) Auto Music Sensing:
Amplifier automatically
turns on when it senses
signal. 1) Power Switch:
Switch to “ON” to turn
on or to use the Auto on
music sensing feature.
2) LED Light:
Green light signifies the
amp is on.
1) Power Switch:
In order to enable the auto on music sensing feature, please see 3.
3) To Enable Auto Music Sensing:
A) Back toggle switch must be set to “RCA” (the down position).
B) Front toggle switch must be set to “AUTO ON”.
C) Power switch must be set to “ON”.
D) With signal, amplifier comes on right away.
E) When there is no signal for three minutes, the amplifier shuts off.
4) Bypass/Lowpass Toggle Switch:
When set to Bypass, it overrides the phase and crossover controls.
They are only to control low frequencies.
5) Phase Setting:
If you are using the XJ-300FR to power a subwoofer, you will
need to set the arrival time of the subwoofer’s frequencies to that of your
speakers. To do this with the highest accuracy, you will need an SPL meter
supplied at most electronics stores.
To set the phase:
A) Send a 50Hz continuous tone signal through the speakers and
the subwoofer at the same time.