Alto-Shaam COMPITHERM 2020ESG - Manual (Page 23)

COMBITOUCH TM ESG SERIES • GAS INSTALLATION MANUAL • 21.
INSTALLATION
WATER SUPPLY & INSTALLATION
WATER REQUIREMENTS
TWO (2) COLD WATER INLETS - DRINKING QUALITY
ONE (1) TREATED WATER INLET:
3/4” NPT*
ONE (1) UNTREATED WATER INLET:
3/4” NPT*
LINE PRESSURE:
30 to 90 psi
2.8 to 6.2 bar
* Can manifold off of one 3/4” line
REFER TO PUBLISHED SPECIFIC WATER REQUIREMENTS
WATER DRAIN:
1-1/2” CONNECTION WITH AIR GAP
Flush the water line at the installation site.
Install water intake filters (provided) [see figure 1]
before connecting the oven to the water supply.
A hose connector is supplied for flexible hose
connection to the COLD water source.
PIPE SEALING TAPE (
TEFLON®
) MUST BE USED
AT ALL CONNECTION POINTS. The use of a pipe
sealing compound is not recommended.
Incoming cold
water connection
T connection
Cold water line
to untreated
oven connection
Cold water
line to filter
or treatment
system Treated cold
water to treated
connection on oven
Water Filter
Install water
intake filters
Fig. 1
ONE SUGGESTED
METHOD OF INSTALLATION
NOTE:
BOTH TREATED AND UNTREATED
WATER CONNECTIONS MUST
BE CONNECTED FOR PROPER
OPERATION OF THE OVEN.
BOTH CONNECTIONS CAN BE
TREATED WATER, BUT SHOULD
NEVER BE CONNECTED TO ONLY
UNTREATED WATER.
UNIONS OR FLEXIBLE LINES
SHOULD BE USED TO ALLOW FOR
OVEN MOVEMENT WHEN BEING
SERVICED OR CLEANING
IS NEEDED.
REFER TO DIMENSION DRAWINGS
BEGINNING ON PAGE 7 FOR
PROPER INTAKE LOCATIONS.
CombiGuard™
FI-23014 shown
Alto-Shaam now offers an improved water filtration
system for Combitherm
® . The CombiGuard™ 10 &
20 triple-guard water filtration system filters dirt,
sediment, and other debris as small as 1/2 micron. This system also
significantly reduces chlorine content to protect against corrosive chorine
compounds. CombiGuard improves equipment efficiency, reduces service
requirements and extends the life of the Combi oven. After installation,
confirm that water quality standards specified in this manual are being met.
Filtration systems include one filter cartridge. Additional cartridges can be
purchased separately. Refer to page 6 for additional ordering information.
The CombiGuard™ BWS Blended Water System utilizes reverse osmosis to
remove more than 97% of the total dissolved solids from water which can be
precisely blended with filtered and treated water.