Vaisala PTB330 - Manual (Page 70)

USER'S GUIDE____________________________________________________________________
68 __________________________________________________________________ M210855EN-D
List of Serial Commands
The bold text in the brackets is the default setting. Enter commands by
inputting them on your computer and pressing the Enter key <cr>.
General commands
BNUM
Shows the device and module batch
numbers.
SERI Shows or sets the serial port settings for
the user port.
SNUM Shows the device and module serial
numbers.
ERRS Shows all unacknowledged errors (and
clears them).
HELP Shows the available commands.
LOCK Shows or sets the keyboard lock.
? Outputs information on the device.
ECHO [ON/OFF] Shows or sets the serial interface echoing.
RESET Resets the device.
VERS Displays the product name and software
version number.
SNUM Shows the device and module serial
numbers.
MODS Acknowledges added or removed modules.
CON Adjusts display contrast.
Measurement commands
R
Changes the serial mode to RUN and
starts outputting measurement results
according to the FORM string (with interval
defined by INTV).
INTV [0...255 s/min/h/d] Shows or sets the continuous output
interval (for RUN mode).
SEND [0...255] Shows the measurement results according
to the configured form.
SMODE [STOP/POLL/RUN
/SEND/PA11A] Shows or sets the start mode.
SDELAY [0...254]
(0... 2540 ms) Shows or sets the answer delay for the
serial line in tens of milliseconds.
ADDR [0...255] Sets the barometer address.
OPEN [0...255] Opens communications after having
entered the CLOSE command.
CLOSE Closes communications until the OPEN
command is entered.
SCOM Shows or sets an alias (a user-specific
form) for the SEND command. The given
alias cannot be a command already in use.