Intv, Echo – Vaisala PTB330 User Manual
Page 88
USER'S GUIDE____________________________________________________________________
86 __________________________________________________________________ M210855EN-D
INTV
Use the command INTV to set the outputting interval for the RUN
mode.
INTV [xxx yyy]
where:
xxx =
Output interval (0 ... 255). 0: the fastest possible output rate.
yyy =
Unit (s, min, h or d)
Example:
>intv 10 min
Output interval : 10 min
>
ECHO
Use the command ECHO to set the user port echo. The command
either enables or disables echo of characters received.
ECHO [x] [y]
where:
x
=
ON (default) or
y = OFF
NOTE
The SERI, SMODE, and ECHO commands change/view the user port
settings even if you are currently connected to the service port.
Example:
>echo off
Echo : OFF
send
pressure = 1013.00 hPa
echo on
Echo : ON
>