Vaisala vNet PoE Network Interface - Manual (Page 30)

24 VAISALA
To save configuration settings:
1
From the vNet Configuration and Management interface,
choose
Utilities | Backup/Restore
.
2
Select the
Backup
tab and click
Backup
.
NetBios-
Name The NetBIOS name used to access the vNet Device.
The name must be 1 to 15 characters long (you can use
any alphanumeric combination and the underscore
character, _ ).
EthDuplex The Ethernet mode the vNet Device uses on the net-
work on which it is installed. Valid duplex values are
Half or Full.
CloseTime-
out The control setting to enable or disable the web inter-
face idle timeout. Valid values are true or false.
IdleTimeout The timeout value in minutes (1 to 120) used if the Clos-
eTimeout = true.
HttpPort The TCP port number the vNet Device uses to display
the web interface.
Device-
Name The vNet Device name displayed in the Digi Device Dis-
covery software. The name can be up to 63 characters
in length.
Contact An informational description saved in the vNet Device.
The description can be up to 63 characters in length.
RealPort The TCP port number the RealPort driver uses to
access the serial port on the vNet Device.
RawPort The TCP port number the Raw TCP driver uses to
access the serial port on the vNet Device.
EnableFan The control setting for the vNet Device fan. Valid values
are on or off.
Enable15V The control setting to enable or disable the 15V loop
power supply output. Valid values are true or false.
Item Configuration
Table 1: Configuration Backup File