Avital AVISTART 4400 - Manual (Page 49)

46 © 2 0 0 4 d i r e c t e d e l e c t r o n i c s , i n c .
p po ow we err ssa avve err m mo od de e
Your system will automatically enter Power Saver Mode while
armed or in Valet ® Mode, after a period of time in which no
operation has been performed. This lowers the current draw on
the vehicle's battery. Power Saver Mode takes over under the
following conditions:
➤ Power Saver when the system is armed: After the system has
been armed for 24 hours the LED will flash at half its normal
rate, decreasing the system's current draw.
➤ Power Saver in Valet ® Mode: When the system enters Valet ®
Mode the LED illuminates steadily. If the vehicle is not used
(ignition is not turned on) for a one hour period while the
system is in Valet ® Mode, the LED will shut off. If the system
remains in Valet ® Mode, the LED will come back on the next
time the ignition is turned on and then back off.
p prro og grra am mm miin ng g o op pttiio on nss
Programming options control your system's normal, operational
set-up. Most options do not require additional parts, but some
may require installation labor.
The following is a list of the programmable options, with the
factory settings in Bold.
➤ A Accttiivvee arming (from remote only) or passive arming (auto-
matic arming 30 seconds after the last door has been closed).
➤ Arming/disarming siren chirps oon n or off.