AEG LAVAMAT 88810 - Manual (Page 37)

37
7. Open the porthole and remove the
polystyrene block fitted with the ad-
hesive tape on the door seal.
8. Fill the smaller upper hole and the
two large ones with the correspond-
ing plastic plug caps supplied in the
bag containing the instruction
booklet.
Important!
All the different plug caps are sup-
plied with the appliance in the plas-
tic bag containing the instruction
booklet.
Connect the water inlet hose as described under the paragraph “Water
inlet”.
Where to install
Important! The appliance must not be used in a room where there is a
danger of frost. Frost damage or impaired operation! Frost damage is
not covered by the warranty.
• The surface on which the appliance is to be installed must be firm
and level. Do not install the appliance on carpets or on soft floor cov-
erings.
• The surface on which the appliance is to be installed must be clean
and dry and free from coverings that move, so that the appliance
does not slide.
• If the location in which the appliance is to be installed is fitted with
small-format tiles, put a rubber mat (available in the shops) under
the appliance.