Axis Communications 540+ - Manual (Page 28)

Adding Printers in Windows
28 AXIS 540+/AXIS 560
Adding NetBIOS/NetBEUI Printers in Windows 2000 using AXIS Print Monitor
See to it that the NetBEUI protocol is installed on your client. Follow the
procedure below to install Axis Printer Ports from a Windows 2000
workstation:
1. To start the Add Printer Wizard, select Settings | Printers from the Start
menu and double-click the Add Printer icon. Start the installation by
clicking Next.
2. The Wizard asks you to select Local printer or Network printer. Select Local
printer. Click Next.
3. Click Create a new port. In the Available Ports dialog, select AXIS Port and
click Next.
4. Select NetBIOS/NetBEUI as your choice of network protocol and click OK.
5. Select the AXIS Port you want to add from the list of available ports. The port
appears as <name>.<port> (Example: AX100086.LP1). The <port> is taken
from the table below. Click
OK.
6. Choose the appropriate printer driver for your printer. Click Next and proceed
directly to step 9. It is only necessary to perform steps 7 - 8 if your printer
does not appear in the list.
Note:
7. Click the Have Disk... button. Insert the printer driver diskette/CD that was
provided with your printer, select the appropriate diskette/CD drive and click
OK.
8. Select the printer driver you want to install and click Next.
9. Enter an appropriate name for your printer and click Next.
10. Choose whether you want to share the printer with other network users and
click Next.
11. Choose whether you want to print a test page, click Next and then Finish.
Ports available Parallel port 1 Parallel port 2 Serial port
AXIS 540+ LP1 — —
AXIS 560 LP1 LP2 CM1
Even if the desired printer is available in the Manufacturers and Printers
lists, you are advised to use the printer driver provided with the printer. This
assures you of the latest driver software.