AMX Sensors and Receivers IR - Manual (Page 19)

Wiring and Installation
15 IR Sensors and Receivers
Installation method B
Use when installing a swivel-mount unit using the provided mounting bracket.
! On drywall, install using the included wall anchors. Use a 3/16-inch drill bit.
! On wood, install using the included #6 mounting screws.
1. If you are installing the IRX-SM+, remove the housing and wire the unit to the AMX IR
receiver as shown in Wiring.
2. If you are installing the AXR-IRSM+, remove the housing and locate the AXlink connector.
FIG. 20 Installation Method A
Two #6 nylon screw anchors and two #6 x 1-inch long screws are provided with each
unit.
FIG. 21 Installation method B