Altinex MULTI-TASKER MT109-102 - Manual (Page 19)

MULTI-TASKER™
400-0343-003 18
18
38. [RMG]
This command may be used to delete an entire
group, or all groups.
REMOVE ONE GROUP MEMBERS
Remove all the members from the group,
effectively deleting the group.
Command Format: [RMGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
Group 1 consists of the cards located in slots
number 1, 2 and 3. Remove all cards from the
group by sending the command [RMG1]. The
system will return the following feedback:
G1=EMPTY
REMOVE ALL GROUPS
Remove all the members from every group,
effectively deleting all groups.
Command Format: [RMG ÜUi]
Ui = Unit ID (i = # from 0-9)
Example:
Group 1 consists of cards 1 and 2. Group 2
consists of cards 1, 2, 3, 4 and 5. Delete all the
groups by sending the command [RMG
Ü]. The
system will return the following feedback:
G1-G8:EMPTY
39. [RD]
This command reads and then displays the
members in each group.
Command Format: [RDGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)
Example:
The cards in slots 1, 2 and 19 are part of
group 5. Read the member data for group 5, by
sending the command [RDG5]. The system will
return feedback as follows:
G1=C1C2C19
The feedback shows G1 (Group 1) and then the
cards that make up Group 1. In this case,
Group 1 includes C1, C2 and C19.
40. [CLRG]
This command clears the members for a single
group or for all groups. The clear command
restores the cards to default settings and is the
equivalent to sending the [CLR] command to
each individual card.
NOTE: Since this command is sending the
[CLR] command to its group members,
each card will display its own reset
message, if any.
Command Format: [CLRGkUi]
Gk = Group ID (k = # from 1-8, or Ü for all)
Ui = Unit ID (i = # from 0-9)
Example:
1) To clear group 1 of Unit ID 0, send the
[CLRG1] command. This command clears
the members for the specified group only.
2) To clear all groups of Unit ID 1, send the
[CLRG ÜU1] command.
41. [CLM]
This command removes the members in a
group and leaves the group empty. It is
equivalent to sending the [RMGkUi] command
without card references.
Command Format: [CLMGkUi]
Gk = Group number (k = # from 1-8)
Ui = Unit ID (i = # from 0-9)