Trouble shooting – Hot Max Torches WP201 User Manual

Page 17

Advertising
background image

KDAR Company

16

Trouble Shooting

Engine Will Not Start

Refill the tank.

NO

Is there fuel in the tank?

Is there oil in the engine?

Add the recommended oil.

YES

NO

Is there a spark from the
spark plug?

Replace the
spark plug.

Take the water pump to an
authorized KDAR water
pump service center.

NO

Still no Spark

YES

To Check:
1. Remove the spark plug cap and clean

any dirt from around the spark plug.

2. Remove the spark plug and install the

spark plug in the plug cap.

3. Set the plug side electrode on the cylin-

der head.

4. Crank engine, sparks should jump

across the gap.

Be sure there is no spilled fuel
in the area.

Gasoline is extremely flamma-
ble and is explosive under cer-
tain conditions.

WARNING

Is the fuel reaching the
carburetor?

YES

Clean the fuel sediment cup
and fuel filter.

NO

To Check:
1. Turn off the engine switch and

loosen the carburetor drain
screw.

2. Fuel should flow from the drain

when the fuel valve is turned on.

If the engine still does
not start, take the water
pump to a authorized
KDAR service center.

YES

NOTE: The nearest KDAR authorized ser-
vice center can be found by visiting
www.hotmaxtorches.com.

Is the fuel valve on?

Is the choke closed?

Is the engine switch on?

YES

YES

YES

Turn fuel valve on.

Move choke to closed un-
less the engine is warm.

Turn engine switch on.

NO

NO

NO

Advertising
This manual is related to the following products: