Kenwood TK-3501E - Manual (Page 11)

3
INSTALLING THE BELT CLIP
1 Remove the battery pack. {p. 2}
2 To install the belt clip, align the
guides of the belt clip with the
grooves on the rear of the battery
pack, then slide the belt clip into
place until the lock lever is secure.
Belt clip
If you are not using a speaker/
microphone or Headset, install the
cap over the speaker/ microphone
jacks using the supplied M3 x 6 mm
screws.
Note:
◆ To keep the transceiver water
resistant, you must cover the
speaker/ microphone jacks with
the supplied cap.
INSTALLING THE CAP OVER THE SPEAKER/ MICROPHONE
JACKS
cap
Lock lever
3 To remove the belt clip, push the
lock lever towards the transceiver
while sliding the belt clip up.