Channel operating frequencies – Kenwood TK-3501E User Manual
Page 20
12
CHANNEL OPERATING FREQUENCIES
To change the operating frequency of a channel:
1 Select your desired channel using the Channel selector.
2 With the transceiver power OFF, press and hold the PTT
switch while turning the transceiver power ON.
• Continue to hold the PTT switch until the LED lights orange
(approximately 2 seconds).
3 Release the PTT switch.
• The transceiver emits a morse code of the current channel
setting. Refer to the table below for the morse code output.
4 Press the Side key to change the Channel Setup number, to
select the new channel frequency.
• Channel Setup numbers and their corresponding operating
frequencies are provided in the table. {p.13}
To set the 0 (OFF), press the Side Key for more than 2 seconds.
• After 1 second, the transceiver will emit a morse code of the
current Channel Setup setting.
5 Press the PTT switch to save the setting.
• The LED will blink red and a beep will sound.
• The transceiver will automatically return to normal operation
when no action is performed for approximately 6 seconds.
Setting
Number
Morse Code
Setting Number
Morse Code
0
—
5
• • • • •
1
• —
6
— • • • •
2
• • —
7
— • • •
3
• • • —
8
— • •
4
• • • • —
9
— •