AMICA 1143.4TsYDX EN - Manual (Page 11)

11
OPERATION
Important!
The inside of the oven should only be washed
with warm water and a small amount of
washing–up liquid.
Important!
The oven’s roasting heater* comes with
height adjustment. When attampting to
clean the top side of the oven, proceed as
follows: -move the heater up carefully,
-slide it towards you and drop.
Once cleaning is complete, move the heater
up again, slide it towards the back wall of
the oven, and insert into slots provided in
the side walls.
The knob is “hidden” in the control panel, so
that either to switch on or to adjust the power
of a given heating one has to:
- push a knob softly and release it,
- set up a knob to the chosen position.
In order to hide a knob:
- push a knob softly home
The position of a knob is specified by a high-
lighted* indicator.
Before using the appliance for the
first time
 Remove packaging, clean the interior of
the oven,
 Take out and wash the oven fittings with
warm water and a little washing-up liqu-
id,
 Switch on the ventilation in the room or
open a window,
 Gently press the knob and turn it clockwise
to or position (see section: Elec-
tronic programmer operation and oven
control)
 Heat up the oven (to a temperature of
250°C for approximately 30 minutes),
remove any stains and wash the interior
carefully.
1
2
Important!
In ovens equipped with the electronic pro- with the electronic pro-
grammer Ts, the time “ 0.00” will start flashing
in the display field upon connection to the
power supply.
The programmer should be set with the cur-
rent time. (See Electronic programmer ). If the
current time is not set operation of the oven
is impossible.
The electronic prgrammer Ts is equipped with
electronic sensors which are switched on by
touching or pressing the sensor surface.
Each sensor reaction is confirmed by the
beep.
Keep the sensor surface clean at all times.
Important!
Before using an oven whose type
contains the letter „O” check fitting of
the heating element in the oven’s side
chamber walls. If the heating element
is not correctly fitted, lift it and insert
into the grooves in the chamber’s
side walls.