ARRI ARRIFLEX 435 - Manual (Page 18)

1 8
WRS System Guide 08/2004
W R S C O M P O N E N T S
Wired Handgrip Attachment 2 (WHA-2)
With this handgrip attachment the hand controllers WFU-1, WFU-3 and/or WZU-1,
WZU-3 or the Wireless Remote Control (WRC-1) can be operated hardwired.
Compatibility: The WHA-2 works with the ARRICAM Studio, the ARRICAM Lite
and the ARRIFLEX 435 Xtreme. It can be connected to the LCS socket of an ARRI-
CAM Lens Data Box or 435 Xtreme with cable LC-M1, LC-M2, LC-Z1 or LC-Z2.
Alternatively it can be connected to the CAC connector of Studio or Lite using cable
KC-70 (3m/9ft). For lens control on an ARRICAM, a Lens Data Box must be present.
The Lens Data Display for Focus Puller (LDD-FP) cannot be attached to the WHA-2.
The WHA-2 can be mounted on the camera with the Rod Bracket or with the Rosette
Bracket.
K2.54079.0 Wired Handgrip Attachment 2
Wired Handgrip Attachment 3 (WHA-3)
The WHA-3, just like the WHA-2, allows all hand controllers except the LDD-FP to
be connected with a cable to an ARRICAM or 435 Xtreme.
In addition the WHA-3 has a button on the left side for focus tracking. Focus tracking
based on measured distances is available when using an ARRICAM or 435 Xtreme
with the Lens Data Display for Focus Puller (LDD-FP) and a compatible distance
measuring device (currently the Cinematography Electronics Cine Tape Measure).
Compatibility: The WHA-3 works with the ARRICAM Studio, the ARRICAM Lite
and the ARRIFLEX 435 Xtreme. It can be connected to the LCS socket of an ARRI-
CAM Lens Data Box or 435 Xtreme with cable LC-M1, LC-M2, LC-Z1 or LC-Z2.
Alternatively it can be connected to the CAC connector of Studio or Lite using cable
KC-70 (3m/9ft). For lens control on an ARRICAM, a Lens Data Box must be present.
The Lens Data Display for Focus Puller (LDD-FP) cannot be attached to the WHA-3.
For focus tracking to work with the WHA-3, the ARRICAM must have at least soft-
ware packet 03E installed. The WHA-3 can be mounted on the camera with the Rod
Bracket or with the Rosette Bracket.
K2.52264.0 Wired Handgrip Attachment 3
WHA-2 Rod Bracket
This bracket is used to mount the WHA-2 and WHA-3 onto support rods. It connects
to the Wired Handgrip Attachment with a quick release dovetail mechanism. Two arti-
culated hinges allow for flexible positioning of the Wired Handgrip Attachment and
attached controller.
Compatibility: Fits on 19mm and 15mm support rods.
K2.52150.0 WHA-2 Rod Bracket
Wired Handgrip Attachment 2 (WHA-2)
Wired Handgrip Attachment 3 (WHA-3)
WHA-2 Rod Bracket