English – Wagner HVLP Conversion Gun User Manual

Page 4

Advertising
background image

4

© Wagner Spray Tech. All rights reserved.

English

Spray Pattern Size

To change the spray pattern size without changing the spray pattern

shape, turn the air cap ring.

Air Cap Ring

Smaller

Pattern

Bigger

Pattern

Turning the ring clockwise will make the pattern bigger. Turning the

ring counterclockwise will make the pattern smaller. As you reduce

the spray pattern size, you will need to move closer to the surface.

adjusting the Material Flow

Each individual job and material may require slight adjustments in

the material flow.
Turn the material flow adjustment knob clockwise for less fluid and

counterclockwise for more fluid.

Less

Fluid

More

Fluid

Material Flow

Adjustment Knob

Spraying

Hold the spray gun between 1 and 8 inches from the spraying surface,

depending on the size of the spray pattern that you need. The closer

to the surface you hold the gun, the smaller the spray pattern.
Keep the gun at right angles to the spraying surface in order to apply

an even coat of material. If you keep the spray gun moving at a

smooth and constant speed, the spray material is less likely to run or

sag.

Correct

Begin

pass

End

pass

Trigger

gun

Release

trigger

Even

stroke

Always squeeze the trigger of the spray gun after you begin your

spray pass and release it before the pass is done. For best results,

make the spray passes about 20 inches long and overlap each pass

by 4 or 5 inches. Remember to keep the gun at right angles to the

spraying surface.

Incorrect

adjusting the Suction Tube

The suction tube on your spray gun lets you get the most out of the

material in your cup no matter at what angle you need to spray.

NOTE: Before adding material to the cup, rotate the suction

tube by hand to the desired direction.

a. If you are going to be spraying in a downward direction, the

angled end of the suction tube should be pointing toward the

front of the gun.

b. If you are going to be spraying in an upward direction, the

angled end of the suction tube should be pointing toward the

rear of the gun.

b

a

Advertising