Aalborg Totalizer - Manual (Page 13)

10
APPENDIX 1
GLOSSARY
Fm Full scale range in [UNIT/MINUTE] for which your transducer has
been calibrated (usually shown on the front label). If engineering
unit is not minute based it has to be converted. For example 300
SCFH has to be converted to 300/60 = 5 cubic feet/minute.
Fs Full scale range specified in UNIT/SEC.
Vs SCALE FACTOR in kHz which corresponds output frequency for
given flow rate (see Table 2).
D DIVISION FACTOR corresponds division of the output frequency
for particular flow rate (see Table 2).