Aalborg Vortex - Manual (Page 100)

95
COMMAND
NAME
DESCRIPTION
NO.
COMMAND SYNT
A
X
COMMAND
ARGUMENT 1
ARGUMENT 2
ARGUMENT 3
ARGUMENT 4
RESPONSE
4-20mA Analog Output Settings
Sets/Reads Analog Outputs assignment, 4mA and 20mA V
alues. NOTE: 4mA and
20mA values have to be entered in corresponding to Argument 2 type EU (for V
o
lum. in %FS). 0 - Disabled.
1-V
o
lum. Flow: Current active
volumetric flow EU. 2-Mass Flow: Current active volumetric flow EU. 3-T
emperature: deg. C 4-Pressure: Pa.
22
AO
<V
alue>
Channel: 1 or 2
<V
alue> Mode: [0-4]
0 - Disabled 1-V
o
l. Flow
2-Mass Flow 3-T
emp.**
4-Pressure**
<V
alue>
4mA value (in EU related to Mode value)
<V
alue>
20mA value (in EU related to Mode value)
Ch1 AO1:0,0,100 Ch2 AO2:2,0.0,26.0
No Argument (Ret. Current settings. For V
o
lum. Flow in %FS)
Ch1. AO1:1,0.0,1000.0 Ch2. AO2:2,0.0,26.0
Data Log
Reads Data Log entries, Sets Mode and Configuration of the data logger
. Argument 1 = C
DL Configuration (Argument2):
0 – Loop Enabled 1 – Loop Disabled 2 – Loop Disabled,
number of samples to record DL Configuration (Argument3): Number of samples: [1-15871] (has to be submitted for all options, but only applicable for Argument 2 value 2). Argument 1 = V
. Process V
ariable:
0-V
o
lumetric Flow 1-Mass Flow
2-T
emperature**. 3-Pressure**
Argument 1 = T 0 – Unconditional 1 – PV Alarm High Event 2 – PV Alarm Low Event
23
DL
M Mode: E – DL Enable D – DL Disable
<V
alue>
E or D
DLM:<value> Example: DLM:E
No Argument (Ret. Current settings)
DLM:<value> Example: DLM:E
C Configuration
<V
alue> [0-2]
<V
alue>
: [1-15871]
DLC:<value>,<value> Example: DLC:0,1024
No Argument (Ret. Current settings)
DLC:<value>,<value> Example: DLC:0,1024
V Process V
ariable
<V
alue> [0-3]
DL
V
:<value> Example: DL
V
:0
No Argument (Ret. Current settings)
DL
V
:<value>
Example: DL
V
:0
I Sample Inter
val in sec.
<V
alue> [1-3600]
DLI:<value> Example: DLI:1
(Ret. Current settings)
DLI:<value> Example: DLI:1
T DL Start/Stop conditions Thresholds
<V
alue>
Start Cond[0-2]
<V
alue>
Stop: [0-2]
DL
T:<value>,<value>
Example: DL
T:0,0
(Ret. Current settings)
DL
T:<value>,<value>
Example: DL
T:0,0