Horner APG SmartBlock HE-579ACM300 - Manual (Page 6)

PAGE 6 12 May 2011 MAN0951-02
HE-559ACM300
Information is subject to change without notice.
5 INSTALLATION / SAFETY
Warning: Remove power from the SmartBlock, CAN port, and any peripheral equipment
connected to this local system before adding or replacing this or any module.
Use the following wire type or equivalent:
•
Belden 8917
• 16 AWG or larger
When found on the product, the following symbols specify:
WARNING: This unit should be located so that it is not accessible without the use of a tool.
WARNING: If this device is used in a way not specified by the manufacturer the safety provided
may be impaired.
WARNING: To avoid the risk of electric shock or burns, always connect the safety (or earth)
ground before making any other connections.
WARNING: To reduce the risk of fire, electrical shock, or physical injury it is strongly
recommended to fuse the voltage measurement inputs. Be sure to locate fuses as close to the
source as possible.
WARNING: Replace fuse with the same type and rating to provide protection against risk of fire
and shock hazards.
WARNING: In the event of repeated failure, do not replace the fuse again as a repeated failure
indicates a defective condition that will not clear by replacing the fuse.
WARNING: Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, adjust, operate, or service this
equipment. Read and understand this manual and other applicable manuals in their entirety
before proceeding. Failure to observe this precaution could result in severe bodily injury or loss
of life.
Warning: Consult user documentation. Warning: Electrical Shock Hazard.
Note: Protective Earth Ground. Must be
connected to the system protective earth
ground for proper and safe operation