Axis Communications AXIS 225FD - Manual (Page 8)

AXIS 225FD - Accessing the Camera
8
Setting the Focus/Zoom
To focus the AXIS 225FD, follow the instructions below.
1. From the Basic Configuration page in the setup tools, open the Focus adjustment page.
2. Set the DC-Iris to Disabled and click Save.
3. Loosen the zoom puller on the lens by turning it
anti-clockwise. Adjust the zoom setting as required.
Re-tighten the zoom puller.
4. Loosen the focus puller on the lens. Adjust the focus as
required. Re-tighten the focus puller.
5. From the Focus adjustment page, set the DC-Iris to Enabled
and click Save.
Notes: • The DC-Iris should always be disabled while focusing the camera. This
opens the iris to its maximum, which gives the smallest depth of field and thus the best conditions for correct
focusing. When the focus is set with this method it will then be maintained in any light conditions.
• Due to the dome’s refraction, the image might appear slightly out of focus once the dome has been placed. To
compensate, focus on an object slightly closer than the intended area.
Accessing the camera from the Internet
Zoom puller
Focus puller
Once installed, the camera is accessible on your local network (LAN). To access the camera from the Internet you must
configure your router/firewall to allow incoming data traffic. For security reasons this is usually done on a specific
port. Please refer to the documentation for your router/firewall for further instructions.
For more information, please visit the AXIS Internet Dynamic DNS Service at www.axiscam.net or, for Technical notes
on this and other topics, visit the Axis Support Web at www.axis.com/techsup