Campbell Scientific GPS16-HVS Garmin GPS Receiver - Manual (Page 21)

Appendix A. CR23X/CR10X Programs
; Write data to final storage every time there is
; a valid read of GPS data
15: Do (P86)
1: 10
Set Output Flag High (Flag 0)
16: Set Active Storage Area (P80)^18796
1: 1
Final Storage Area 1
2: 101 Array ID
; Write datalogger based time stamp
17: Real Time (P77) ^27570
1: 0011
Hour/Minute,Seconds (midnight = 0000)
; Write GPS based time stamp
18: Sample (P70) ^6080
1: 3
Reps
2: 20 Loc [ Hours ]
; Set resolution to high for latitude and Longitude
19: Resolution (P78)
1: 1
High Resolution
20: Sample (P70) ^20303
1: 4
Reps
2: 2 Loc [ LatDegMin ]
; Write elevation in meters
21: Sample (P70) ^32246
1: 1
Reps
2: 10 Loc [ Elevation ]
; Set resolution low
22: Resolution (P78)
1: 0
Low Resolution
; Write the number of satellites in view
23: Sample (P70) ^1910
1: 1
Reps
2: 7 Loc [ NumSats ]
; Reset the the GPS quality number
24: Z=F x 10^n (P30)
1: -1
F
2: 00 n, Exponent of 10
3: 6 Z Loc [ Quality ]
25: End (P95)
26: End (P95)
End Program
A.1.6 Troubleshooting
The first step is to verify that it really does not work. With the Garmin16-HVS
running and the datalogger program running, look at the input location for GPS
Quality Number. This location will show a one when the Garmin16-HVS
output is picked up by the datalogger. The input location for parsed time and
position are good locations to check. The location for seconds should update
every time the GPS data is updated.
If the GPS time and position data are not shown in the input locations, check
the communication cable wiring.
A-7