2 installation tasks, 1 indoors, Installation tasks – Campbell Scientific ET107 Evapotranspiration Monitoring Station User Manual
Page 13: Indoors, 2. cut flap packing tape, 3. shipping box packaging
ET107 Weather Station
1.2 Installation Tasks
1.2.1 Indoors
•
Immediately upon receipt of your shipment…
⇒
Weather station is packed in the shipping box in layers. See FIGURE
1-2, FIGURE 1-3, FIGURE 1-4, and FIGURE 1-5.
⇒
Immediately upon receipt of your shipment…
Open shipping carton(s).
Set the large weather station carton down lengthwise on a floor or
table top. Position the box as shown in FIGURE 1-2.
Cut the tape along the edge of the lower flap first. See FIGURE 1-2.
Cut the tape around the remaining flaps BUT only cut one layer deep.
Lift up the cardboard flaps exposing the top layer of foam as shown in
⇒
Check contents against invoice and shipping checklist. Contact CSI
immediately about any shortages.
FIGURE 1-2. Cut flap packing tape
FIGURE 1-3. Shipping box packaging
Top Packing
Foam Layer
Middle Packing
Foam Layer
Bottom Packing
Foam Layer
ET107,
Top Layer
ET107,
Bottom Layer
Cut Lower Flap
Edge First
3