B.2 installation – Campbell Scientific ET107 Evapotranspiration Monitoring Station User Manual
Page 94
Advertising
Appendix B. PS24 24 Ahr Power Supply and 10 x 12 inch Enclosure
B.2 Installation
The PS24 is purposely shipped without the battery mounted
in its bracket. Do not install the battery until instructed to do
so.
1. Place the top enclosure bracket on the pole at approximately 40 inches
above the bottom of the pole. The bracket should be installed with the
hook side up, and facing north.
2. Slide the strut clamps into the bracket as shown in FIGURE B-4. Tighten
the clamp so that it doesn’t move.
Do not over tighten the clamp!
FIGURE B-4. Strut clamps in brackets
CAUTION
CAUTION
B-4
Advertising