Campbell Scientific Raven110 GPRS/EDGE Digital Cellular Modem - Manual (Page 30)

Appendix C. Configuring the Raven for PPP
Use WirelessAce to configure the following PPP settings:
• HOSTPRIVMODE = 1
• HOSTPRIVIP = 192.168.1.1
This will configure the Raven to use NAT (Network Address Translation).
These settings should be configured by the template.
Use WirelessAce to configure the following UDP setting:
• MD = 02-PPP
After the changes have been made, click the Write icon to save the changes in
the modem
.
Click the Reset icon to restart the modem. The other ways to reset the modem
are by pressing the reset button on the front of the modem or removing the
power from the modem.
Click the Disconnect icon to terminate communications with the modem.
C-2