Campbell Scientific RF450 Spread Spectrum Radio - Manual (Page 5)

FCC Notifications
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions: 1) This device may not cause harmful interference
and 2) this device must accept any interference received, including
interference that may cause undesired operation. This device must be operated
as supplied by Campbell Scientific, Inc. Any changes or modifications made
to the device without the express written approval of Campbell Scientific, Inc
may void the user's authority to operate the device.
The module number FGR09 has a maximum transmitted
output power of 955mW. It is recommended that the
transmit antenna be kept at least 23cm (approximately 10
inches) away from nearby persons to satisfy FCC RF
exposure requirements. CAUTION
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
• Consult an experienced radio/TV technician for help
• Consult Campbell Scientific