Campbell Scientific TD Operating System Addendum for CR510, CR10X, and CR23X - Manual (Page 7)

TABLE DATA ADDENDDUM
AD-5
Section 12 The TD operating system does not use the output Flag 0.
Commands dealing with it are not valid.
Instruction 92 – There is no option for minutes, time is in seconds
only.
Instructions Not In TD OS:
Instruction 96 – Serial Output
Instruction 98 – Send Character
Instruction 111 – Load Program from Flash
New Instructions for PakBus:
Instruction 190 – Send or Get Input Locations
Instruction 191 – One way Final Storage Data Transfer
Instruction 192 – PakBus Message
Instruction 193 – Wireless Network Master Control
Instruction 194 – Time Until Transmit
Instruction 195 – Set Clock from Address
Instruction 196 – Wireless Remote
Instruction 197 – Force Route Through Address
Section 13 No Change
Section 14 No Change