Campbell Scientific T.Weather T107 Toro Weather Station - Manual (Page 48)

T107 Weather Station
FIGURE 2-30. Loosely Drape Antenna Cable over Back of Enclosure
3. Use the 2.125 stainless steel U-bolt to attach the adjustable angle mounting
bracket to the pole. Depending on the size of the antenna position the
bracket directly below, or above, the enclosure top mounting bracket. The
top of an omni directional antenna should not be higher than the top of the
lightning rod.
Slide the U-bolt behind the pole and through the oval notches on the
adjustable angle mounting bracket (see FIGURE 2-31). Put a flat washer,
lock washer, and a silicon bronze nut, in that order, on the ends of the U-
bolt. Tighten the nuts finger tight to allow the angle bracket to rotate
around the pole.
40