Campbell Scientific Wireless Sensor Network (CWB100, CWS220, and CWS900) User Manual
Page 55
Advertising
Appendix A. Using DevConfig for CWS Setup
7. If configuring a CWS900 sensor module, you can use DevConfig to ensure
that the sensor is correctly configured and connected to the CWS900. To
test the sensor, connect the sensor to be measured to the CWS900 and
follow the instructions above for establishing communication with
DevConfig. When the sensor settings are displayed in the Deployment
tab, click on the Settings Editor tab. The field called Measurement will
display the most current measurements from the sensor with updates every
5 seconds.
8. When finished, click on Disconnect and repeat the process for the next
sensor or close DevConfig.
A-3
Advertising