Avocent EVR1500-AM - Manual (Page 16)

12 EVR1500 Installer/User Guide
AC Power Cord
DC Power
Module
Serial Port
Analog Sensors Digital Inputs/
Outputs
USB Ports
Installing the EVR1500 Environmental
Monitor Appliance
Figure 2.2 illustrates one possible configuration for your EVR1500
environmental monitor appliance. Follow the detailed set of procedures
following Figure 2.2 to successfully install the appliance.
Figure 2.2: Basic EVR1500 Environmental Monitor Appliance Configuration
WARNING: To reduce the risk of electric shock or damage to your equipment-
- Plug the power cord into a grounded (earthed) outlet that is easily accessible at all times.
- Disconnect the power from the appliance by unplugging the power cord from either the
electrical outlet or the DC power supply.
To install the EVR1500 environmental monitor appliance:
1. Using an Unshielded Twisted Pair (UTP) CAT 5 cable, connect the
network port on the back of the EVR1500 environmental monitor
appliance to your LAN.
2. On the back of the appliance, under Analog Sensors, insert sensor cables
supplied by Avocent or a third party into any of the RJ-45 ports. Place the
sensor in the desired location. See Appendix C for pinout information.