Avocent EVR1500-AM - Manual (Page 44)

Chapter 3: Basic Operations 41
To confi gure an SNMP trap:
1. After launching the web GUI, click Confi guration - SNMP Traps. The
SNMP Traps window displays a list of pre-confi gured traps.
Figure 3.18: SNMP Traps Window
2. Click the name of the trap you wish to edit.
- or -
Click the Create New button to add a new trap. A new row is added to the
SNMP Traps table.
The trap information displays in the dialog box.
3. Click the Enabled checkbox to enable the trap.
NOTE: An enabled SNMP trap is available for use in the following operations: Combination
actions, Thresholds, Rules and Timed Rules.
4. Type a new name for the trap in the Unique name fi eld. The name cannot
contain any spaces, and the only special character allowed is
the underscore (_).
5. Type the address of the Network Management System (NMS) or the trap
collection system in the Manager host or IP (trap collection) fi eld. The
EVR1500 environmental monitor appliance will send the traps to
these locations.
6. Type a port number for the NMS or trap collection system in the Port on
the manager fi eld.