Agilent Technologies Agilent 82350B - Manual (Page 20)

1 Installing and Configuring the 82350B
8 82350B Installation and Configuration Guide
2 Remove PC Cover. Remove power from the PC and from all
of its peripherals. Then, remove the power cord from the PC.
Unlock and remove the cover from the PC to allow access to
the I/O slots. See your PC documentation for instructions.
Figure 1-5 Remove the PC cover
3 Remove a Cover Plate. Remove one of the PC back panel
cover plates. The 82350B is a 5V PCI card and will not fit in a
3.3V PCI slot or in an EISA or ISA slot. Choose a 5V PCI slot
that will give adequate clearance for the GPIB connector.
Figure 1-6 Remove the card slot
4 Install the 82350B. Insert the 82350B Interface Card edge
connector into the PCI expansion slot connector of the PC.
Make sure the interface is fully seated by pushing firmly on
the top edge of the card with the palm of your hand. The
GPIB connector should extend through the back panel
opening to allow GPIB cable connection. If you install more
than one 82350B, you may want to install the cards so there
is at least one empty slot between 82350Bs. When inserting
the 82350B, be sure to hold the card by its edges. Also, be
careful with the metal faceplate around the GPIB connector
as the faceplate can be bent.