Nilfisk-ALTO CLE8.0 - Manual (Page 12)

11
You need to be aware that higher ratio settings produce less natural sounds so if you wish a more minute effect
on the dynamic range of a program you should use a Ratio of 4:1 or lower.
4.2.3 Attack control
Output
Hard Knee
Threshold Gain 0 dB
Ratio 2:1
Ratio 4:1
Limiter :1
SKC Curve
Input
Chart.5: SKC characteristic of the compressor section
4.2.4 Release Control
4.2.5 Auto switch
4.2.6 Output control
4.2.7 Bypass Switch
4.2.8 Gain Reduction eter M
If you have a ratio of 2:1 this means that for every 2dB increase of the input level (above threshold) you will
get an increase of output level of 1dB. ON the same way, a ratio of 10:1 means that for every 10dB increase
of the input level (above threshold) you will get an increase in output level equal to 1dB, and so on.
With the SKC circuit (Smart Knee Control) you can avoid aggressive compression generated by using high
ratios. How we achieve this? Introducing a "soft knee" curve in the range of up to 10dB above the threshold
level. Hard Knee compression is then used beyond this range.
The attack time represents the amount of time that passes before the compressor start to lower the output
level when the signal is above the threshold point. For very fast transients such as drums, handclaps, etc.
a short attack time will be used. These peaks are consequently carefully regulated by the compressor.
Sounds of other nature will get advantages if longer attack times are used. Anyway, our advice is always to
begin the process with longer attack times. Then you can start gradually to reduce the attack time. In the
CLE 8.0 the attack time can be set in a range of 1 to 150 milliseconds.
This control determines how much time the compressor needs to get back to normal gain when the audio
signal falls below the set threshold.
A too short release time will make the volume to fluctuate and you will experience pumping effect. A too long
release time will give you pumping and breathing effect especially when you have loud passage followed by
a quite passage. The release time on CLE 8.0 can be set from 0.05 to 5 seconds.
This Control is indispensable to compensate the loss of level at output level generated by the gain reduction
caused by the compression and limiting processing
This switch turns off the possibility of manually set the attack and release times. An intelligent program re-
cognition circuit will automatically set the attack and release times. In such way, undesirable effects such as
distortion and pumping will be avoided.
This consists of 8 LED on the front of the CLE 8.0. Through this Led meter you can visualise the amount of
gain reduction at any given time.
This switch simply turns off the processing of the corresponding channel. This is useful to compare quickly
the processed and unprocessed signal.